DS3232SN#T&R【PDF 16/19 页】IC RTC W/TCXO 20-SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录1994

12页 13页 14页 15页 [16页]17页 18页 19页

Extremely Accurate I2C RTC with

Integrated Crystal and SRAM

Data Transfer on I2C Serial Bus

SCL

NOTE: TIMING IS REFERENCED TO VIL(MAX) AND VIH(MIN).

SDA

STOP

START

REPEATED

START

tBUF

tHD:STA

tHD:DAT

tSU:DAT

tSU:STO

tHD:STA

tSP

tSU:STA

tHIGH

tLOW

Note 2: Limits at -40°C are guaranteed by design and not production tested.

Note 3: All voltages are referenced to ground.

Note 4: ICCA—SCL clocking at max frequency = 400kHz.

Note 5: Current is the averaged input current, which includes the temperature conversion current.

Note 6: The RST pin has an internal 50k

Ω (nominal) pullup resistor to VCC.

Note 7: After this period, the first clock pulse is generated.

Note 8: A device must internally provide a hold time of at least 300ns for the SDA signal (referred to the VIH(MIN) of the SCL signal)

to bridge the undefined region of the falling edge of SCL.

Note 9: The maximum tHD:DAT needs only to be met if the device does not stretch the low period (tLOW) of the SCL signal.

Note 10: A fast-mode device can be used in a standard-mode system, but the requirement tSU:DAT

≥ 250ns must then be met. This

is automatically the case if the device does not stretch the low period of the SCL signal. If such a device does stretch the

low period of the SCL signal, it must output the next data bit to the SDA line tR(MAX) + tSU:DAT = 1000 + 250 = 1250ns

before the SCL line is released.

Note 11: CB—total capacitance of one bus line in pF.

Note 12: Minimum operating frequency of the I2C interface is imposed by the timeout period.

Note 13: The parameter tOSF is the period of time the oscillator must be stopped for the OSF flag to be set over the voltage range of

≤ VCC ≤ VCC(MAX) and 2.3V ≤ VBAT ≤ 3.4V.

Note 14: This delay only applies if the oscillator is enabled and running. If the EOSC bit is 1, tREC is bypassed and RST immediately

goes high.

WARNING: Negative undershoots below -0.3V while the part is in battery-backed mode may

cause loss of data.

DS3232

Maxim Integrated

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式